LinkBack URL
About LinkBacks
Reply With QuoteHey TK,
how can I help you?
Hendrik
This is a discussion on Audi A4 Problems No Start No Spark/Pulse within the Audi A4 Forum forum part of the Audi category; 96 A4 No Start No Spark/Inj Pulse Substitute Good Parts (All) OBD Shows No Engine Rpm Wiring Good To Ecm...
Senior Member
Audi A4 Problems No Start No Spark/Pulse
96 A4 No Start No Spark/Inj Pulse Substitute Good Parts (All) OBD Shows No Engine Rpm Wiring Good To Ecm
Administrator
Hey TK,
how can I help you?
Hendrik
Any problems? Pleased to help.
Senior Member
96 A4 shows no rpm obd Swapped everything with running same vehicle could this be alarm problem? Seems to be plain ign key vehicle started went four blocks then quit help!!!!
Senior Member
Still Need Help with no start OBD shows no rpm all wires to ecm trace out good crankshaft mark clean flywheel teeth perfect ign switch new no wires found for alarm on switch how does alarm disable start system? thanks
Administrator
Hey,
getting any error codes? It sounds like a starting sensor is damaged. Or just nothing and then the problems you described?
Hendrik
Any problems? Pleased to help.
Senior Member
Only Code With OBD Shows No Rpm Both Sensors Swapped With Running Vehicle Wiring To Computer Checked With Ohmmeter Old Parts Start&Run Fine In Other Vehicle Timing Marks Perfect Cam Turning & Cam Sensor Changed No Spark&No Injector Pulse On Ground Side Voltage To Everything Under Hood Not Too Much Hair Left On My Head
Administrator
Hendricius and I talked. Both are unsure what could cause this problem. I am asking another member on the forum which can hopefully help you a bit more!
Juergen
Member
Did you ever figure out what the problem was? I am having the same issue with my 97 A4. I dont seem to have any power going to the crank sensor. However the sensor seems to test out ok when checking the ohms. I was told that it could be the ECM. Did you check yours?
Best regards,
Chadz Audi
Audi Addicted Admin
Hello Chadz welcome to Audi Forum,Originally Posted by Chadz Audi
Most probable cause of this malfunction would be due to the Flywheel, I suggest you to get it checked by your Audi service or local mechanic and replaced if found problematic or the other probable reasons may be Bad wiring from the sensors to the ECU or Bad ECU itself.
Regards
R.B.N.J
Got a problem? Happy To Help
Chadz Audi (25-11-2009), Dileep (25-11-2009)
Member
I had someone else say that they thought it was the ECM as that is where the crank sensor gets its power and there is no power going to the sensor. Is there a way to test the ECM/ECU? Does anyone know where the ECM/ECU is located?
Best regards,
Chadz Audi
Posting Permissions 
